Light Hood with closed mouth and mashed eyes exclusive by
Prices incl. VAT plus shipping costs
- Order number: MRL526.s
Our light full masks will fit any head snugly like a second skin.
They are sewn from particularly soft and slightly elastic aniline leather (see additional information below), creating a very flattering appearance.
The leather will fit snugly on any head, clearly showing its shape below. The tighter the mask is worn, the more obvious this effect will be.
This version’s mouth is shut, while the perforated eye area allows the wearer very good use of eyes but will markedly interfere with speaking.
This means that this version is a lot more restrictive than the versions with a hole for the mouth. A ball-gag put in before tying the mask would be slightly visible but massively enhance restrictiveness.
If needed, you can of course add a blindfold (like our narrow eye-mask ML111).
Vital! Please note:
The nose-area only has very small air-holes for breathing. If you close the eye-area, the influx of air may be reduced further. It may be necessary to enlarge the air-holes or add further holes in this case.
Available in four sizes.
Please refer to the table below to find your size.
Size chart: Leather Masks
(all measurements are in centimetres!)
|Circumference of neck ||33-36 ||36-39||39-42||42-45|
|Circumference of head at mouth ||46-51||49-54||52-58||57-61|
|Circumference of head above eyebrows ||52-56||55-59||58-62||61-65|
|Circumference of head: tip of chin - back of head ||63-66||65-68||67-70||69-72|
Advice for easy putting-on of mask:
First open the lacing all the way to the top.
As soon as the mask has been pulled over the head, do not immediately pull the cords tight at the top. Instead evenly pull the cords all the way down without using too much force. After this, slowly tighten from top to bottom until the mask is at the desired tightness.
This way of tightening is necessary in order to guarantee the mask’s perfect fit. If you start by pulling the upper part very tight, the entire mask may ride up and create the impression of not fitting.
What does Aniline Leather mean?
Do not let the material’s name confuse you. Historically, this type of leather has been dyed using aniline-based dyes, but today it refers to a particular natural, high-quality leather.
You can find more detailed information here:
Aniline leather is tanned and subsequently dyed using entirely water-soluble dyes. In contrast to nappa leather, no additional pigment layer is applied, as this would hide small imperfections. This means that aniline leather can only be made from skins that have no wounds or marks whatsoever, which results in only five out of 100 being of sufficient quality.
The result of this is aniline leather being particularly pleasant, optically as well as haptically. Also it is slightly elastic to the pull in one direction. This is an advantage when being used for our light full-head masks, as it makes them particularly tight and snug-fitting, almost like a rubber mask.
As its surface lacks a pigment layer, aniline leather is not waterproof. You should avoid spilling food or drink on the mask.
To clean only wipe the mask down with a damp cloth. Do not use grease or oil.
If the leather should lose some of its softness after a while, simply massage it using your hands. It will quickly become as soft and supple as new.
Please measure the following areas with a tape measure. Alternatively you can use a thread or cord which after marking can be measured with a ruler.
The most important measurement is the circumference of head: tip of chin - back of head
If you are unsure, please send us the single measurements and we will be glad to help you further!
A: Circumference of neck
B: Circumference of head at height of mouth
C: Circumference of head at height of eyebrows
D: Circumference of head: tip of chin - back of head (longest distance)